Place the base on the floor and make sure it is level. Add the backside panel. Insert two screws at the bottom.

Hold it firmly until step 2 is completed!

Add the right side panel. Insert two screws at the bottom and one at the top. Tighten the corner screw in the middle.

You can now let go of the backside panel!

Screw in the shelf support bolt.
Slide on the shelf.

Make sure no cables are in the way!

Add the left side panel.
Insert two screws at the bottom and one at the top. 

Tighten the corner screw in the middle!

Screw in the left bolt underneath the shelf. Place 2 half-moon washers followed by the nuts on both sides.

Remove the box cover below the shelf.

Plug in the cable coming from the bottom into the power strip in the box. It’s the 1st slot closest to the back panel. When you insert the plug you need to hear it click. Next, plug in the cable coming from the top of the back panel. It goes into the remaining slot.

Again, make sure you hear it click!

Put the ceiling panel on top of the booth in a resting position just before it fits into place.

Connect the cables from the backside panel to those of the ceiling panel.

Finish sliding on the ceiling panel.
Insert the screws from the top.

Slide on the door.
Attach the interior door handle.

Check that the door is straight & level with the booth!

You are ready!